Rubber molded products refer to a diverse group of vulcanized rubber products which are manufactured in a mold and the desired size and shape is obtained.

Use of Rubber Products

Rubber products are usually divided into three Main Categories:

(1) tires,

(2) Industrial rubber goods used in motor-vehicle, aircraft, and ship construction, agricultural machine building, railroad transport, and construction, and

(3) consumer goods, including footwear (the most important in this category), mats, bathing caps, inflatable inner tubes and rubber rings, gloves, and pacifiers.

Most rubber products are made from hard raw rubber, although some are made from latexes, for example, seamless gloves with thin walls, rubber thread, and foam-rubber seats for automobiles and furniture.

Rubber Molded Products

Rubber molded products refer to a diverse group of vulcanized rubber products which are manufactured in a mold and the desired size and shape is obtained. Molded rubber products include diaphragms, vibration isolation devices, air springs, bushings, and all kinds of pads, boots, wiper blades, chassis bumpers, fascia, conveyor wheels, grommets, and more. They are used in a wide range of services.

Molding Process

Compounded rubber is transferred, injected or simply put into heated molds, and cured to obtain required size and shape under pressure.

Things to consider for Molded Rubber

Molded rubber needs to maintain certain tolerance standards to produce the finished products. There are many factors which affect tolerances in the manufacturing of molded solid rubber products. These factors are peculiar to the rubber industry and are given below:

Environmental Storage Conditions

Temperature: Rubber changes in dimension with changes in temperature. It is necessary to specify a temperature at which the parts are to be measured and the time required to stabilize that part at that particular temperature.

 Humidity: There are few rubber materials which absorb moisture. Hence the dimensions of the product are affected by the amount of moisture in it. This can be minimized by stabilizing the product in an area of controlled temperature and humidity for not less than 24 hours.

Dimension Terminology

            fixed dimensions are not affected by flash thickness variation.

            ClosureDimensions are affected by flash thickness variation.

Trim and Finish

The main purpose of trimming and finishing operations is a to remove rubber material, like flash, which is not part of the finished product.This is possible often without affecting important dimensions, but in some cases; some material is removed from the part itself.

Inserts

Most insert materials like metal, fabric, plastic, etc. have their own standard tolerances. When designing inserts for molding to rubber, other factors like fit in the mold cavities, the location of the inserts with respect to other dimensions, proper hold spacing to match with mold pins, room temperature must be considered.

Mold Design

Molds can be designed and built to varying degrees of precision at the different cost. With any type of mold, the mold builder must have some tolerance. That is why each cavity has some variance from the others.Dimensional tolerances on the rubber product must include allowances for this fact. Most molded rubber goods are made in two plate molds and the complicated ones require three or more plates.

Distortion

Since rubber is a flexible material affected by temperature, distortion can occur when the part is removed from the mold or when it is packed for shipment. This distortion makes it difficult to measure the parts accurately.However, some distortion can be minimized or removed by storing the part unstressed as possible for 24 hours at room temperature.

Shrinkage

This is the difference between the corresponding linear dimension of the mold and of the molded part. All rubber materials display some amount of shrinkage after molding when the part cools. The mold designer and the compounded must measure the amount of shrinkage and which is incorporated into the size of the mold cavity. Even though the mold is built to anticipate shrinkage, there is always an inherent difference which must recover by adequate dimensional tolerance. 

Complex shapes in the  Rubber Molded Product may restrict the linear shrinkage in one direction and increase it in another. The rubber manufacturer always aims at minimizing these variables, but they cannot be eliminated altogether.  Source: https://encyclopedia2.thefreedictionary.com/Products


Share Your Mood?

Facebook Conversations